Installation guide

Configuring digital and SIP phone feature buttons 10-32
Chapter 10: Configuring Phones
Wave Global Administrator Guide
Restrict feature
Blocks the user’s Caller ID from being displayed to the distant party (the user’s Caller ID will
be displayed as “Private”.) This feature only applies to the current call—it must be enabled on
a call-by-call basis.
Phone type: Digital.
Required settings: None.
Optional settings: None.
Save/Repeat feature
Allows a user to temporarily store a dialed number while hearing ringback or while connected
on a call, and then redial the saved number later.
Phone type: Digital.
Required settings: None.
Optional settings: None.
Self Park feature
Places a call in a parked state on a user’s primary line appearance for retrieval from another
phone. You can include one Self Park button per phone.
In the General Setting applet, PBX (Advanced) tab, in the Call Park group box, you can specify
the Self park
n minutes before ring back setting. In the Self park drop-down list, select the
number of minutes that Wave waits for a user to pick up a self-parked call. If the call is not
picked up within the specified time, Wave rings the extension at which the call was parked. If
you specify unlimited minutes, then Wave does not ring back the extension.
Phone type: Digital, SIP.
Required settings: None.
Optional settings: None.
Release 2.0
September 2010