Installation guide

Configuring digital and SIP phone feature buttons 10-21
Chapter 10: Configuring Phones
Wave Global Administrator Guide
Note: If you do not select either 2.5 mm or Bluetooth, 2.5 mm is used as the default setting
to support a standard headset. If you select
Bluetooth, but the phone does not support that
capability, the standard headset mode (
2.5 mm) is assumed.
Hold feature
Places a call on hold while the phone goes on-hook, allowing the user to make another call or
use other phone features. You can include one Hold button per phone.
Phone type: Digital.
Required settings: None.
Optional settings: None.
Line Appearance feature
Line appearance for an extension other than the extension assigned to the Primary line button,
allowing the user to answer calls to more than one extension from the same phone. Line
Appearance buttons are also used to answer calls on a specific Call Navigator queue.
You can include multiple Line Appearance buttons on a phone.
Phone type: Digital, SIP.
Required settings:
Extension. Any valid extension number. The extension number can be a primary extension
on another phone, or a virtual extension. (A virtual extension does not appear as a primary
line on another phone—see page 16-36 for information about configuring virtual
extensions.)
Optional settings:
•
Do not ring the telephone. If checked, disables ringing when a call is received on this line
appearance. If checked, this setting also disables the
Receive splash ring when off hook
setting (described below) if it is checked.
•
Receive call waiting tone when off hook. If checked, a beep sounds if the user is off hook
and another call arrives on the line. A beep also sounds if an incoming call hangs up or is
forwarded before answering.
Release 2.0
September 2010