Installation guide

Configuring private networking 9-37
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
Enabling the new destination access code
Every external first digit that is configured in the First Digit Table for a private network is
displayed in the Destination Access Codes tab of the Access Codes dialog in the Outbound
Routing applet. By default, an access profile does not allow access to a destination access code
until permission is granted by the system administrator.
If there are users that do not need access to your private network, you can set up an Access
Profile for those users and not grant permission for the new destination access code(s).
So, the last step in configuring private networking is to grant permission for the new destination
access code.
To enable the new destination access codes
1 If necessary, click the Administration tab of the Management Console.
2 Click the Outbound Routing icon, located in the Trunk Administration section.
The Outbound Routing applet starts.
3 Select the access profile you want to configure for private networking, then click
Edit.
Alternatively, you can select
New to add an access profile. Refer to “Configuring specific
access profiles” on page 9-14 for information about adding access profiles.
Click
Release 2.0
September 2010