Installation guide

Configuring private networking 9-30
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
You need to make decisions about or determine the following things:
• Which external first digit do you want to use for your access code?
• Do you want to use a one-digit or two-digit external access code?
• What length do you want your location codes?
When you dial within the private network, you will be prepending the location code
to the extension of the person you are calling. Be sure to specify a length long enough
to accommodate all the Wave Servers on your network. You can specify a location
code length of 2, 3, 4, 5, or 6 digits. The default value is 3. A location code cannot
start with a 0.
• Determine a Home Location Code for each Wave Server in your network.
Configuring outbound routing for private networking
You need to specify the following information about your private network in the Outbound
Routing applet:
• Length of your location codes
• Length of your user extensions
• Home Location Code for this Wave Server.
You also need to specify ranges of location codes and identify the routing table that you want to
use with each range.
To configure location codes in the Outbound Routing applet
1 If necessary, click the Administration tab of the Management Console.
2 Click the Outbound Routing icon, located in the Trunk Administration section.
Click
Release 2.0
September 2010