Installation guide

Configuring destination access code routing 9-28
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
To enable destination access codes
1 If necessary, click the Administration tab of the Management Console.
2 Click the Outbound Routing icon, located in the Trunk Administration section.
3 Select an access profile from the list, then click
Edit, or click New to create a new access
profile.
4 Click the Destination Access Codes tab.
5 Select the
Permission Allowed check box to enable this access profile to use the specified
destination access code.
6 Click
OK to close the Access Profile dialog.
7 Repeat steps 3 through 6 for each access profile that you want to edit or add.
8 Click
Apply to save your changes.
9 Click
Done to return to the Management Console.
Later, when you are configuring extensions and telephones, you will assign specific access
profiles to each extension.
Click
Release 2.0
September 2010