Installation guide

Configuring off-premise extension routing 9-22
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
• Destination. Select a destination trunk group (or Signaling Control Point for IP
telephony) from the drop-down list. (Signaling Control Points have the following
format: IP|Signaling Control Point name.
•
ISDN Settings. If you selected a trunk group that is associated with an ISDN trunk in
the Trunk Configuration applet, you can select an ISDN setting from the drop-down
list. If you do not select a trunk group that is associated with an ISDN trunk, this field
is disabled. For more information about how to configure ISDN settings, refer to
“Configuring digital channels for ISDN” on page 5-34.
7 Repeat steps 5 and 6 to add steps to the routing table.
8 Click the
Up or Down to move a selected step up or down in the list.
The order of the routing steps is important. Wave tries placing the call to the destination
specified in the first step. If the specified trunk is busy, disabled, or disconnected, the
system tries the next routing step, and so on. The caller will hear a fast busy tone if all steps
have been tried unsuccessfully.
9 Click
OK to close the Routing Table dialog.
All routing tables are available throughout the Outbound Routing applet. You can use the
same routing tables for different outbound routing steps and requirements, but be aware
that some places in the applet may require different translation, hence different routing
tables.
10 Click
Apply to save your changes.
11 Click
Done to return to the Management Console.
Configuring off-premise extension routing
This section provides information about configuring outbound call routing to off-premise
extensions. See “Off-premise extensions” on page 29-12 for examples and information about
why you might use off-premise extensions. To set up Wave Server to dial off-premise telephone
numbers as if they were extensions, you need to complete the following tasks:
• Creating off-premise extension ranges. See page 9-23.
• Configuring the off-premise extension table. See page 9-23.
Release 2.0
September 2010