Installation guide

Configuring automatic route selection 9-21
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
The Routing Table dialog opens.
4 If this is a new routing table, enter a descriptive
Name.
5 Click
Add to add a new step to the routing table.
6 For each step, you can click in the fields and edit the following settings, depending on the
translation your CO requires.
•
Strip First n Digits. Enter the number of digits, if any, that you want to strip from the
beginning of the outgoing telephone number.
Note: The external access code digit (for example, 9) does not need to be stripped. It
is not included in any call routing decisions after the call type is determined.
•
Keep Last n Digits. Enter the number of digits, if any, that you want to keep at the end
of the outgoing telephone number.
Note: For a particular route step, you can enter a value into either the Strip First Digits
or
Keep Last Digits field. Entering 0 for Strip First Digits will not remove any digits.
Entering 0 for Keep Last Digits will remove all the digits.
•
Prepend Digits. Enter the digits that you want to add to the beginning of the outgoing
telephone number.
•
Postpend Digits. Enter the digits that you want to add to the end of the outgoing
telephone number.
Release 2.0
September 2010