Installation guide

Configuring automatic route selection 9-20
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
This tab allows you to specify which external access codes configured in the First Digit
Table may be used by this access profile. External access codes may be used to provide
access to external paging systems or specific trunks on the Wave Server. (If this tab is
blank, you have not configured any external access codes in the First Digit Table.)
13 To allow users with the access profile you are creating or editing to use an access code,
select the code in the list and select the
Permission Allowed check box. To block users with
this access profile from using the access code, leave the check box deselected.
14 Click
OK to close the Access Profile dialog.
15 Click
Apply to save your changes.
16 Click
Done to return to the Management Console.
Configuring outbound routing tables
You can access outbound routing tables through the Outbound Routing applet.
To add or edit an outbound routing table
1 If necessary, click the Administration tab of the Management Console.
2 Click the Outbound Routing icon, located in the Trunk Administration section.
3 Click an
Edit Routing Table button or choose (New Routing Table) from any of the
following places.
• Area code tables
• Special digits table
• Off-premise extension table
• Privileges
Click
Release 2.0
September 2010