Installation guide

Configuring automatic route selection 9-19
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
10 For International Routing Table, Local Operator Routing Table, and Long Distance
Operator Routing Table
, select one of the following from the drop-down list:
• A routing table that has already been defined.
•
*Blocked*. Select this option to block all calls to the area or office codes.
•
(New Routing Table). Select this option to open the Routing Table dialog. See
“Configuring outbound routing tables” on page 9-20 for instructions.
To edit the currently-selected routing table, click
Edit Routing Table to open the Routing
Table dialog.
11 For
Carrier Access Code Destination leave the *Blocked* option selected unless you want
your users to dial carrier access codes. Otherwise, select one of the following from the
drop-down list:
• A trunk group for the call. Note that you cannot assign a routing table to the carrier
access code since no translation is required.
•
*Ignored*. This option strips the carrier access code and routes the call as a regular
long distance call.
12 Click the Destination Access Codes tab.
Release 2.0
September 2010