Installation guide

Configuring automatic route selection 9-13
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
Configuring the Area Code table for ViewPoint analog dialing
You must configure Wave as follows to support automatic dialing from ViewPoint over analog
lines.
1 If necessary, click the Administration tab of the Management Console.
2 Click the Outbound Routing icon, located in the Trunk Administration section. The
Outbound Routing applet opens.
3 Click
Edit Global Access Profile. The Global Access Profile dialog opens.
4 Click the Area Code Table tab if it is not already selected.
5 Add the following rules to the Area Code Table:
• To add support for 11-digit dialing for specific exchanges, add a new entry in the area
code table, enter the area code and a range of Office Codes (exchanges), then create a
new routing table and specify to keep the last 7 digits and to prepend 1+XXX where
XXX is the area code.
• To add support for 10-digit dialing for specific exchanges, add another entry in the area
code table, enter the area code, a non-overlapping range of Office Codes (exchanges),
then create a new routing table and specify to keep the last 7 digits and to prepend XXX
where XXX is the area code.
• To support 7-digit dialing for the remaining exchanges, add yet another entry in the area
code table, enter the area code, leave the Office Code at “Default”, then create another
routing table and specify to keep the last 7 digits and prepend nothing.
Click
Release 2.0
September 2010