Installation guide

Configuring automatic route selection 9-11
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
12 Click Add to add an entry to the Area Code Table. A new row is added to the list.
13 To enter the
Area Code and Office Code Range for the new area code, double-click in each
column in the new row, and then enter the codes for which you are providing routing
instructions.
•
Area Code. Enter the area code for which you want to specify routing instructions that
apply to all outgoing calls. You might want to add an entry to block outbound calls
with an area code of 900. Enter
Default to allow all area codes.
•
Office Code Range. Enter the office code (or a range of office codes) within the
specified area code. Enter
Default to match any office code within the specified area
code.
Release 2.0
September 2010