Installation guide

Configuring automatic route selection 9-4
Chapter 9: Configuring Outbound Call Routing
Wave Global Administrator Guide
4 To edit a dialing service, double-click it in the view. The Dialing Service dialog opens.
5 Type the dialing service
Name.
6 Add any notes about the dialing service in
Comments.
7 Select the
Show in ViewPoint checkbox if you want this dialing service to be available for
use in all
Call Using lists in ViewPoint.
8 Click
OK.
Configuring the Global Access Profile
Wave examines the Global Access Profile settings prior to examining the specific access profile
for an outbound call.
Note: To support automatic dialing from ViewPoint over analog phone lines, you must
reconfigure the Global Access Profile. For instructions, see “Configuring the Area Code table
for ViewPoint analog dialing” on page 9-13.
Release 2.0
September 2010