Installation guide

Configuring inbound routing tables 8-6
Chapter 8: Configuring Inbound Call Routing
Wave Global Administrator Guide
• Dialed Number. Default (any number received), or contains a string of zero or more
digits, followed by a string of 0 or more x characters. This string may be as large as 32
characters. The dialed number column directly represents the digits expected to be
sent from the CO with an inbound call. For example, enter a three-digit number
beginning with a 2 as the value 2xx.
Note: Default is a wildcard value, indicating that any number, of any length, is accepted.
6 Enter the destination information.
•
Destination. Contains a string of zero or more digits, followed by a string of 0 or more
x's. This string may be as large as 32 characters. This number is interpreted as if
dialed from an internal station. For example, enter a three-digit extension number
beginning with a 1, as the value 1xx. If the destination is an external telephone
number, append the external access digit (configured in the First Digit Table) before
the telephone number.
•
DNIS Name. No value required. If the value in the Dialed Number field is a DNIS
number, enter a description up to 32 characters long. This description overwrites the
calling party (call source) information and is displayed on the display panel of the
destination extension. This string identifies the number that the caller dialed.
7 Enter a night answer mode from the
Night Answer drop-down list.
The available Night Answer Modes are as follows:
•
Not Used. disables the Night Answer Mode
•
Use System Default. uses the Default Night Answer Destination specified in the
General Settings applet
•
User Defined. uses the destination that you enter in the Night Answer Destination
field and overrides the system default specified in the General Settings applet
8 Select a rule, and click
Up and Down to rearrange the rule order.
If you are using Scheduled Routing and there is overlap in the schedule, the rules must
appear in order of precedence.
9 Click
OK to return to the host applet.
10 Click
Apply to save your changes.
11 Click
Done to return to the Management Console.
Release 2.0
September 2010