Installation guide

Configuring 10-digit dialing 7-6
Chapter 7: Initial Call Routing Configuration
Wave Global Administrator Guide
4 Enter your home area code in the Local Area Codes text box, and then click Add.
The area code is displayed in the list below the field.
Do not specify any additional area codes unless your calling area requires 10-digit dialing
for local area codes. See “Configuring 10-digit dialing” on page 7-6.
The area code that you enter is also displayed in the
Home Area Code drop-down list.
5 Select your
Home Area Code from the drop down list.
6 Click
Apply to save your changes.
7 Click
Done to the Management Console.
Configuring 10-digit dialing
Configure 10-digit dialing when certain telephone numbers that include the area code do not
require that a 1 be dialed before dialing the telephone number.
To configure 10-digit dialing
1 If necessary, click the Administration tab of the Management Console.
2 Click the First Digit Table icon, located in the PBX Administration section.
3 Click the Local Area Codes tab.
4 Enter each area code in the
Local Area Codes text box, and click Add to add it to the list.
Note: If you must dial a 1 before using an area code, do not enter that area code in the Local
Area Codes
list.
Note: Be sure that your home area code is selected in the Home Area Code drop-down list.
5 Click
Apply to save your changes.
6 Click
Done to return to the Management Console.
Note: In some cases you might want to have users dial ten digits but your service provider
requires 11 digits for calls to specific area codes. You will need to add a 1 to the number before
placing the call. To configure this digit manipulation, see “Configuring outbound routing
tables” on page 9-20.
Click
Release 2.0
September 2010