Installation guide

DTMF transport settings
Caution: The default values in this pane will work for most VoIP networks. These are
expert settings that should not be modified unless you are instructed to do so by your
Vertical Technical Support representative to address specific VoIP network
requirements or issues.
To configure the DTMF transport settings
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Telephony icon, located in the PBX Administration section.
3 In the left pane, expand System Parameters and then click
DTMF Transport Settings.
Click
Release 2.0
September 2010