Installation guide

Adjusting IP call quality parameters 6-43
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
Comfort noise
Caution: This is an expert setting that should not be modified unless you are instructed
to do so by your Vertical Technical Support representative.
This option generates comfort noise during silences on the receiving end of the phone call in
calls where silence suppression is enabled. Comfort noise is white noise that masks “dead” time
in a phone conversation. Use this option to simulate a circuit-switched phone conversation. This
option is enabled by default.
To adjust the comfort noise settings
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Telephony icon, located in the PBX Administration section.
3 In the left pane, expand System Parameters and then click Advanced Codec Settings.
Click
Release 2.0
September 2010