Installation guide

Adjusting IP call quality parameters 6-40
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
3 In the left pane, expand System Parameters and then click Advanced Codec Settings.
4 Specify the range of acceptable delay in the
Jitter Buffer Size drop-down lists.
5 Select the
Enable Dynamic/Adaptive Jitter checkbox (this is the default setting).
The Dynamic/Adaptive Jitter feature optimizes the jitter buffer based on voice traffic and
network conditions. If you disable this feature, the Wave system adheres to the values in
the Nominal and Maximum fields.
6 Click
OK.
Release 2.0
September 2010