Installation guide

Configuring bandwidth management zones 6-38
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
4 Select Remote Default from the table, and click Edit.
5 Configure the bandwidth settings, inter-zone codecs, and intra-zone codecs as explained in
“Configuring the home zone” on page 6-30.
Note: For security reasons the default Bandwidth Management Across Zone Boundary
setting is No Calls.
Note: You do not configure IP address ranges in the Remote Default zone configuration
because this zone is used to manage bandwidth for all calls from IP addresses not defined in
any of your configured zones.
6 Click
OK to close the Bandwidth Management dialog.
7 Click
Apply to save the remote zone configuration changes.
Release 2.0
September 2010