Installation guide

Configuring bandwidth management zones 6-37
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
5 Enter a Name for the zone.
6 Configure the IP address ranges, bandwidth settings, inter-zone codecs, and intra-zone
codecs as explained in “Configuring the home zone” on page 6-30.
7 Click
OK to close the Bandwidth Management dialog. The new zone is displayed in the list.
8 Click
Apply to save the new remote zone configuration.
Configuring the remote default zone
To configure the remote default zone
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Telephony icon, located in the PBX Administration section.
3 Select Zones from the Bandwidth Management folder.
Click
Release 2.0
September 2010