Installation guide

Configuring bandwidth management zones 6-34
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
Note: Be sure to use the option that most accurately reflects the type of data link used
in this zone. If you need to use a different value than those provided, enter the value in
the
Custom ___ bytes field.
•
Custom ___ bytes. Enter a custom data link overhead in the field provided.
Note: This helps the Wave system calculate Inter-zone bandwidth availability for IP
calls. This setting must be changed if the physical data link type across this zone is
changed.
7 Configure the inter-zone codecs.
a Select the Inter-Zone Codecs tab. The default codecs are displayed in a table.
b You can edit the default settings, and add and remove records in the table.
• To change the default settings, select any of the table cells. Audio Codec and
Packet Time are selected from those drop-down lists. Silence Suppression is
enabled by checking that check box.
• To add a codec to the list click
Add.
• To remove a codec, select a codec in the table and click
Remove.
c Click
Up or Down to change the order of the codecs.
Release 2.0
September 2010