Installation guide

Configuring bandwidth management zones 6-33
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
6 Configure the bandwidth settings.
a Select the Bandwidth Settings tab.
b Select a
Bandwidth Management Across Zone Boundary setting.
•
No Calls. No calls are allowed to IP addresses outside the ranges defined in this
zone.
•
Unlimited Calls. All calls to or from all IP addresses are allowed.
•
Calls Limited by Bandwidth (Kbps). Calls placed to or received from IP addresses
outside this zone are limited to the number that can be supported by the bandwidth
specified here.
c Select a
Data link overhead across the zone boundary setting.
•
Standard. Select one of the standard data links from the drop-down list. The
option you select determines the amount of overhead the system adds to the
bandwidth when calls cross the zone boundary. Specifying enough overhead is
important in preventing too many calls from being placed over the WAN link; if
the transport overhead is not included, then more calls would be allowed than the
link could support.
Release 2.0
September 2010