Installation guide

Configuring bandwidth management zones 6-28
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
Enabling IP call bandwidth
SIP phones cannot make external calls until the bandwidth is allocated for them. To do this,
configure the Home bandwidth management zone in “Configuring the home zone” on
page 6-30.
Changing the password for the IPPhone user account
The IPPhone account is not used unless FTP access required. For security reasons, Vertical
Communications recommends that you change the password for the IPPhone user account from
the default password of Vertical4VoIP!
To change the password for the IPPhone user account
1 Log on to the Management Console.
2 Open the Password Administration applet.
3 In the Password Administration dialog, click the IPPhone user account and click
Edit.
4 Enter the new password in the
Password and Confirm Password fields.
5 Click
OK.
6 Click
Done.
Configuring bandwidth management zones
Configure the home, remote and default remote zones using the procedures in this section. For
information about the bandwidth management zones, see “Bandwidth management” on
page 28-10.
Review the following topics to configure bandwidth management zones
• Zone configuration recommendations
• Codec negotiation
• Configuring the home zone
• Configuring remote zones
• Configuring the remote default zone
Release 2.0
September 2010