Installation guide

Configuring SIP phones 6-25
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
Configuring Vertical-branded SIP phones
The configuration process for Vertical-branded SIP phones is similar to that of digital phones,
as described in Chapter 10. This section describes the following additional configuration tasks
specific to Vertical branded SIP phones. For tasks that apply to your configuration, perform the
indicated steps at each Vertical-branded SIP phone. Be sure to follow the steps for your specific
phone model.
• Optional: Configuring a static IP address for Vertical-branded SIP phones. See
page 6-25.
• Required: Configuring the TFTP server to synchronize Vertical-branded SIP phones
with the Wave Server. See page 6-26.
• Optional: Setting date and time on Vertical-branded SIP phones. See page 6-27.
Configuring a static IP address for Vertical-branded SIP phones
This task is optional, depending on how you want to assign an IP address to a Vertical-branded
SIP phone.
• By default, a Vertical-branded SIP phone’s IP address is dynamically assigned via
DHCP. If you want to continue using this default method, go to the next section,
“Configuring the TFTP server to synchronize Vertical-branded SIP phones with the
Wave Server” on page 6-26.
• If you want to assign a static IP address to the phone, perform the steps below on all
Vertical branded SIP phones. Be sure to perform the steps specific to your phone
model.
1 To configure a static IP address on a Vertical-branded 9133i, 9112i, 480i, or 480i/CT SIP
phone:
a Press the Options button.
b Select
Network Settings from the main menu. When prompted, enter the password
(the default password is 22222.)
c Go to step 3.
Release 2.0
September 2010