Installation guide

Configuring site-to-site call routing for IP telephony 6-21
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
4 Click Edit Inbound Routing Table to specify the call sources, schedules, and routing.
For more information about editing the Inbound Routing Table, see “Configuring inbound
routing tables” on page 8-4.
Note: If you want to route all incoming calls as received, there is no need to edit the inbound
routing table. Only edit the inbound routing table if you want to route by schedule or do
inbound digit translation.
5 Choose an extension from the
Intercept Destination drop-down list.
6 Select an access profile in the
Access Profile for Tandem Calls drop-down list.
7 Click
Apply to save your changes.
Including Signaling Control Points in the outbound call routing configuration
To route outbound calls to IP call destinations, select Signaling Control Points instead of trunk
groups in your outbound call routing configuration.
To include Signaling Control Points in outbound call routing
While you are configuring your outbound call routing, select a Signaling Control Point
from the
Destination drop-down list at the point when a trunk group might be selected.
The following graphic shows an example of configuring an outbound routing table in the
Outbound Routing applet:
Release 2.0
September 2010