Installation guide

Configuring site-to-site call routing for IP telephony 6-20
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
Configuring default inbound IP call routing
To specify how to route incoming IP calls from unknown sources (that is, sources that are not
included in your list of Signaling Control Points), configure the call handling rules with the
default inbound call routing settings.
To configure default inbound IP call routing
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Telephony icon, located in the PBX Administration section.
3 Select
Default Inbound Routing from the Call Routing folder.
Click
Release 2.0
September 2010