Installation guide

Configuring site-to-site call routing for IP telephony 6-19
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
Setting the route step timeout
You can adjust the amount of time that a Signaling Control Point step in an outbound routing
table is given to operate before the system tries the next step in the table. Increasing this timeout
(the maximum is 30 seconds) will help allow for network or other delays.
To set the Signaling Control Point route step timeout
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Telephony icon, located in the PBX Administration section.
3 Select
Signaling Control Points from the Call Routing folder.
4 In the
Route Step Timeout drop-down list, select the number of seconds before the system
times out and tries the next step in an outbound call routing table.
Click
Release 2.0
September 2010