Installation guide

Configuring site-to-site call routing for IP telephony 6-15
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
11 If you selected Register with a Proxy/Registrar in step 9, complete the following two
sections:
a In the Authentication Settings section, select the
Authentication Required checkbox if
the if the destination SIP endpoint requires authentication.
b For the following fields, enter the authentication credentials (
Authentication Name
and
Password) provided by the remote SIP endpoint administrator. These three fields
are disabled until you select any of the checkboxes in the previous step. These fields
are required when they are enabled.
•
Authentication Name. 1-32 alphanumeric characters. Authentication name cannot
match an existing extension plus last name (for example, “Ryan605”), another
SCP's authentication name, or the SIP global authentication name.
•
Password. 1-48 characters.
•
Verify Password.
c In the Registration Settings section, select the
Registration Required checkbox if the
SIP destination endpoint requires registration. Then, enter the
Registrar Server
address and
Registrar Port number provided by the remote SIP endpoint
administrator.
12 Select one of the following from the
Preferred DTMF Transport drop-down list, based on
the requirements of your ITSP or SIP trunk provider:
•
Inband (DTMF digits are left as tones in the original audio stream)
•
RFC 2833
• SIP INFO
Note: This setting indicates a preference only - most ITSPs and SIP trunk providers use or
prefer RFC 2833. If RFC 2833 is used by your ITSP or SIP trunk provider, Wave will
automatically use RFC 2833, no matter what you specify here. On the other hand, if RFC
2833 is not supported by your ITSP or SIP trunk provider, Wave will use the setting that you
specify.
Release 2.0
September 2010