Installation guide

Configuring site-to-site call routing for IP telephony 6-14
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
9 In the Inbound \ Outbound section, specify whether the SIP destination endpoint requires
authentication or registration, based on the requirements of your ITSP or SIP trunk
provider. Typically, authentication and registration are required for third-party SIP servers.
This SCP will: The setting you choose here depends on which of the following
scenarios applies to you:
This SCP is connecting to another Wave Server. In a Wave Server-to-Wave
Server configuration, you have 2 choices:
If registration is required between the Wave Servers, select Receive
registration from Contact
when configuring the SCP on one Server, and
Register with a Proxy/Registrar when configuring the SCP on the other
Server. It does not matter which setting you select on either Server, as
long as the settings are different on each Server.
If registration is not required between the Wave Servers, select Receive
registration from Contact
when configuring the SCPs on both Servers,
and then select
Not Required in step 10.
Go to step 10.
This SCP is registering to an ITSP. Select Register with a Proxy/Registrar, and go to
step 11.
10 If you selected
Receive registration from Contact in step 9, complete the following two
sections:
a In the Authentication Settings section, select one of the following from the
Authentication drop-down list:
Not Required. Select this option if the SIP destination endpoint represented by this
SCP does not requires authentication, for example a Wave Server-to-Wave Server
configuration where registration is not required.
Custom. Select this option to define SIP endpoint authentication settings specific
to this SCP. For a description of how to use these settings, see “Setting up global
SIP endpoint authentication parameters” on page 6-6.
Use SIP Defaults. Select this option if this SCP uses the global SIP endpoint
authentication settings you specified in “Setting up global SIP endpoint
authentication parameters” on page 6-6.
b In the Registration Settings section, select the
Registration Required checkbox if the
SIP destination endpoint represented by this SCP requires registration.
Go to step 12.
Release 2.0
September 2010