Installation guide

Configuring site-to-site call routing for IP telephony 6-11
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
4 Click New to add a new SCP, or select an existing SCP to edit, then click Edit. The
Signaling Control Point dialog opens.
5 Enter a
Name for the SCP.
When you configure outbound call routing, this name will appear as IP, a vertical bar (|),
and the name you enter here. For example, if you enter New York, it will be displayed as
IP|New York in your outbound call routing configuration. See “Including Signaling Control
Points in the outbound call routing configuration” on page 6-21 for more information.
Note: The Name field accepts alphanumeric characters as well as the following special
characters: ‘~!#$%&*()-=+|{};:“,./<>?
Release 2.0
September 2010