Installation guide

Configuring site-to-site call routing for IP telephony 6-9
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
6 Enter the following information in the SCP Settings section, based on the level of
authentication you require. See your Vertical support representative for more information
about how to use these settings.
•
Authenticate Register
• Optionally Authenticate:
•
Invite
• Re-Invite
• BYE
7 For the following fields, enter the authentication credentials provided by the remote SIP
endpoint administrator. These three fields are disabled until you select any of the
checkboxes in the previous step. These fields are required when they are enabled.
•
Authentication Name. 1-32 alphanumeric characters. Authentication name cannot
match an existing extension plus last name (for example, “Ryan605”) or another
SCP's authentication name.
•
Password. 1-48 characters.
•
Verify Password.
8 Click
Apply to save your changes.
Configuring Signaling Control Points
You configure a Signaling Control Point (SCP) to determine how to handle IP calls to and from
a specific IP address that represents a SIP destination endpoint. The following steps also
describe how to configure SIP endpoint authentication settings specific to this SCP.
You can adjust the amount of time that a Signaling Control Point step in an outbound routing
table is given to operate before the system tries the next step in the table. See “Setting the route
step timeout” on page 6-19.
To configure a Signaling Control Point
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Telephony icon, located in the PBX Administration section.
Click
Release 2.0
September 2010