Installation guide

Configuring site-to-site call routing for IP telephony 6-6
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
You set up SIP endpoint authentication parameters in the several places:
•
To set up global SIP endpoint authentication parameters that are used unless a specific
SCP has its own authentication parameters
, you use the IP Telephony applet, SIP
Advanced Parameters dialog (Global Authentication tab). See “Setting up global SIP
endpoint authentication parameters” on page 6-6.
•
To to set up SIP endpoint authentication parameters for a specific SCP, you use the IP
Telephony applet, Signaling Control Point dialog (SIP Settings tab). See “Configuring
Signaling Control Points” on page 6-9.
•
To specify a user’s SIP endpoint authentication password, you use the User/Group
Management applet, User dialog (Phone tab). See “Supplying a SIP authentication
password” on page 11-56.
Setting up global SIP endpoint authentication parameters
Perform the following steps to set up global SIP endpoint authentication parameters that are
used unless a specific SCP has its own authentication parameters.
To set up global SIP endpoint authentication parameters
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Telephony icon, located in the PBX Administration section.click
Click
Release 2.0
September 2010