Installation guide

Configuring site-to-site call routing for IP telephony 6-3
Chapter 6: IP Telephony Configuration
Wave Global Administrator Guide
Configuring site-to-site call routing for IP telephony
You configure call routing in order to use Signaling Control Points for the following outbound
call routing scenarios:
•
Automatic route selection. See “Automatic route selection” on page 29-8.
•
Off-premise extensions. See “Off-premise extensions” on page 29-12.
•
Destination access codes. See “Destination access code/direct to trunk group” on
page 29-13.
See Chapter 9 for information about configuring outbound call routing.
To configure call routing for IP call destinations you will need to perform the following
procedures:
• Enabling IP telephony or SIP signaling protocols. See page 6-3.
• Setting up SIP endpoint authentication. See page 6-5.
• Configuring Signaling Control Points. See page 6-9.
• Configuring default inbound IP call routing. See page 6-20.
• Including Signaling Control Points in the outbound call routing configuration. See page
6-21.
Enabling IP telephony or SIP signaling protocols
Perform the following steps to enable the SIP signaling protocol on the Wave Server. Note that
you need to do so to use SIP phones with Wave, even if you are not using SIP trunks.
To enable IP telephony or SIP signaling protocols
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Telephony icon, located in the PBX Administration section.
Click
Release 2.0
September 2010