Installation guide

Configuring digital trunks and channels 5-39
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
4 Click OK to save your changes.
5 Repeat these steps for the other ports on the Quad BRI module.
To configure channels on the Quad BRI Module
1 In the Trunk Configuration applet, select the channel or channels on the Quad BRI Module
that you want to configure, and then select the
Enabled checkbox.
Note: The Signaling setting defaults to B-channel and cannot be changed. The Transmit
Gain
and Receive Gain settings do not apply to the Quad BRI Module and are disabled, as
well as the
Impedance button.
2 Select the
Trunk Group for the selected channels from the drop-down list.
3 Enter any additional
Notes for reference.
Release 2.0
September 2010