Installation guide

Configuring digital trunks and channels 5-36
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
Configuring ports and channels on the Quad BRI Module
The Quad BRI Module supports ISDN Basic Rate Interface (BRI) digital trunks. The Quad BRI
Module provides connectivity between the Wave Server and Central Office (CO) equipment
supporting Euro-ISDN BRI communication protocols.
The Quad BRI Module supports 4 Euro-ISDN BRI trunks and up to 8 simultaneous voice calls.
Note: The following procedures call out information specific to configuring ports and channels
on the Quad BRI Module. For more about general trunk and channel configuration settings not
described in detail here, see “Configuring digital trunks and channels” on page 5-21. Also, refer
to your Service Confirmation Letter or contract to determine specific settings to use.
To configure ports on the Quad BRI Module
1 If necessary, click the Administration tab of the Management Console.
2 Click the Trunk Configuration icon, located in the Trunk Administration section.
Click
Release 2.0
September 2010