Installation guide

Configuring digital trunks and channels 5-35
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
Assigning digital channels to a serial interface
1 If necessary, click the Administration tab of the Management Console.
2 Click the Trunk Configuration icon, located in the Trunk Administration section.
1 Select the
Data option.
Hint: Unlike other data channels, you can select and configure non-contiguous channels for
the serial interface.
2 Select the Serial connection to use from the
Connection drop-down list.
3 Click
Apply to save your changes.
4 Click
Done to return to the Management Console.
Typically, assigning channels to the serial connection is all you need to do. You might want to
ensure that your serial interface’s configuration is correct, or make some changes to it, if your
connection is not working.
For more information, see “Ensuring that the T-1 serial interface is set correctly” on page 14-1.
Click
Release 2.0
September 2010