Installation guide

Configuring digital trunks and channels 5-30
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
5 Click Apply to save your changes.
6 Click
Done to return to the Management Console.
Configuring digital channels for voice
1 Be sure that the channels are enabled—to do so, select the
Enabled check box.
2 Select the signaling method from the
Signaling drop-down list.
For T-1 voice channels, E&M Wink Start (FGP), E&M Immediate Start, or Ground Start
are valid options.
If you have a fractional T-1 trunk, be sure all voice channels that are not in service on your
trunk have the
Enabled check box unchecked.
Note: If you chose the ISDN trunk type when you configured the T-1 module settings, Wave
automatically sets the
Signaling fields for channels 1 through 23 to B-channel; channel 24
is automatically set to D-channel.
Release 2.0
September 2010