Installation guide

Configuring digital trunks and channels 5-29
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
Configuring digital channels
1 Select the card or module according to the steps in “Configuring digital trunk card or
module settings” on page 5-22.
2 Display the card or module channels, and select the channels you want to configure.
Note: If you checked the ISDN check box at the digital card or module level in step 4 on
page 5-24, you will see channel settings for
ISDN and Data here at the channel level. If you
did not check the ISDN check box, you will see channel settings for
Voice and Data here.
3 Select
Voice or Data. Note that if you selected ISDN previously, your choices are ISDN or
Data.
4 Configure the appropriate settings based on the channel type.
• For voice channels, complete “Configuring digital channels for voice” on page 5-30.
• For data channels, complete “Configuring digital channels for data” on page 5-33.
• To assign channels to a serial interface, complete “Assigning digital channels to a
serial interface” on page 5-35.
Note: For ISDN channels, Channel 24 is automatically set to D-Ch, None.
Release 2.0
September 2010