Installation guide

Configuring digital trunks and channels 5-22
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
At the digital channel level:
• If you choose a Courtesy reset, changes are applied immediately if the channel is
idle. If the channel is not idle, calls in progress are allowed to complete, but all new
inbound and outbound calls on the channel are blocked. When the channel is idle,
your changes will be applied.
• If you choose a Forced reset, changes are applied immediately. Any active calls
are disconnected, and all new inbound and outbound calls on the channel are
blocked until the channel is reset.
• After installing a digital trunk module in a Wave Server and configuring the trunks and
channels on the module, trunks and channels on existing digital trunk modules may go
offline. To resolve this issue, do the following:
a Edit one of the affected existing digital trunks via the Trunk Configuration applet.
b Select the channels on the trunk.
c Deselect the
Enabled checkbox, and then click Apply.
d Select the
Enabled checkbox again, and then click Apply.
e Repeat these steps for on any other affected digital trunk modules.
Configuring digital trunk card or module settings
To configure the digital trunk card or module settings
1 If necessary, click the Administration tab of the Management Console.
2 Click the Trunk Configuration icon, located in the Trunk Administration section.
Click
Release 2.0
September 2010