Installation guide

Configuring analog trunks 5-16
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
Configuring analog channels
To configure a card or module’s analog channels
1 Select the card or module according to the steps in “Configuring analog trunk card or
module settings” on page 5-15.
2 Click the + next to a card or module to display the channels, and select the channels you
want to configure.
• To select a contiguous range of channels, select the first channel in the range, then
hold down the Shift key while you select the last channel in the range.
• To select a noncontiguous range of channels, hold down the Ctrl key while you select
each channel.
Release 2.0
September 2010