Installation guide

Configuring analog trunks 5-15
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
Configuring analog trunk card or module settings
To configure the analog trunk card or module settings
1 If necessary, click the Administration tab of the Management Console.
2 Click the Trunk Configuration icon, located in the Trunk Administration section.
3 Select the card or module you want to configure, then select the
Trunk in Service check
box.
Note: If your Wave Server only has a Integrated Services Card and no other analog trunk
modules, there will only be one entry in the list,
Integrated Services Card - Loop Only.
Refer to the Wave Server Hardware Reference Guide for information about each card and
module installed in your Wave Server.
4 Configure the card or module’s analog trunks or ports, which are called channels (see
“Configuring analog channels” on page 5-16).
5 Click
Apply to save your changes.
6 Click
Done to return to the Management Console.
Click
Release 2.0
September 2010