Installation guide

Deleting a trunk group 5-12
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
The following information is displayed for each conflict:
•
Trunk Group. Name of the trunk group that is still in use.
•
Profile. Access profile name where the hunt group is used, for example “Global
Access Profile”, “Private Network”, or custom access profile name.
•
Category. Category within the access profile, for example Area Code Table,
Off-Premise Extension Table, Special Digits Table, Privileges, and so forth.
•
Routing Table. Name of the routing table where the conflict exists, or “None” for
Privileges or Carrier Access.
•
If the trunk group you selected is still configured for one of the external digits in the
First Digit Table
, the Cannot Delete Selected Trunk Group dialog opens:
Important: Make a note of the conflicts so that you can address all of them.The trunk group
in question cannot be deleted until all outstanding conflicts have been resolved.
7 Click
OK. The Trunk Groups applet closes automatically. In the Outbound Routing applet,
remove the trunk group in question from the configuration to resolve all identified
conflicts. Then run the Trunk Groups applet again and delete the trunk group.
Release 2.0
September 2010