Installation guide

Creating a new trunk group 5-7
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
7 In the External Caller ID section, specify how to provide Caller ID for outbound calls:
•
Use External Caller ID from User Configuration. Select this option to send the
information specified for the user as entered in the User/Group Management applet.
(Unless modified for an individual user, this will be the default information specified
in the General Settings applet.)
•
Send Company Name and Main Number. Select this option to send the Company
Name
and Main Number, as entered in the System tab of the General Settings applet.
Note: Although Company Name can include up to 16 alphanumeric characters, be
aware that no more than 15 Caller ID characters can be sent over an ISDN trunk.
•
Send Station Name and Internal Extension Number. Select this option to send the
Station Name, as entered in User/Group Management applet.
•
Send Station Name and this Number. Select this option to send the Station Name (as
entered in User/Group Management applet) followed by the digits you enter. (Use this
setting to provide station name and number on outbound calls.)
In addition, if you select the
plus last ___ digits of calling extension number
checkbox, the specified number of digits from the calling extension are appended to
the digits you entered.
•
Do Not Send Caller ID. Select this option if you do not want to provide external Caller
ID.
8 In the Hunt Order section, select one of the following:
•
Linear. Looks for a free channel, always starting at the beginning of the list of trunks
in the trunk group and searching to the end, or—for reverse-order hunting—always
starting at the end of the list and searching to the beginning.
•
Circular. Looks for a free channel, starting where the last search left off. From this
point (where the last search left off), forward-order hunting works forward through
the list of available channels, and reverse-order hunting works backward through the
list.
For either hunt order type, select the
Reverse Order checkbox as applicable.
For more information about hunt order types, see “Trunk group hunt types” on page 27-7.
Release 2.0
September 2010