Installation guide

Creating a new trunk group 5-5
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
• Direction. Select In, Out, or Both to specify the direction of the trunk group. Your
Service Confirmation Letter should detail the direction of your installed—refer to it to
determine which direction to select.
Individual service providers may use different terms to describe trunk direction for
voice circuits, for example:
• “In”, “inbound” (with respect to the Wave Server)
• “Out”, “outbound” (with respect to the Wave Server)
• “Both”, “bidirectional”, “two-way”, “2-way”, “in and out”
• Select the
Enable Outside Line functionality checkbox to create an outside
line-enabled trunk group. Note that selecting this checkbox enables the Outside Line
Properties tab as well as the
Use Outside Line Inbound Routing setting on the In tab.
5 If this trunk group will be used for inbound calls, click the In tab to specify how inbound
calls are to be handled.
See “Configuring trunk groups for inbound call routing” on page 8-1 for information on
how to use the fields on this tab.
Release 2.0
September 2010