Installation guide

Creating a new trunk group 5-4
Chapter 5: Configuring Analog and Digital Trunks
Wave Global Administrator Guide
3 Click New to create a new trunk group. The Trunk Groups dialog opens.
4 At the top of the dialog, enter the following information:
•
Name. Enter a name or phrase for the new trunk group, using up to 16 alphanumeric
characters. This trunk group name will appear on Caller ID phones when calls are
received via this trunk group and no Caller ID was received.
Hint: Wave ISM automatically identifies an outside line-enabled trunk group when it
displays the trunk group’s name in other applets (for example, Trunk Configuration)
by prefixing the trunk group’s name with “OL|”. You may want to indicate in an
outside line-enabled trunk group’s name whether it is a Single Call or Multiple Call
variant outside line (selecting a variant is described in the following procedure.) This
will make it easier later on to identify the trunk group and its qualities when you
configure the trunks associated with the trunk group, via the Trunk Configuration
applet.
Release 2.0
September 2010