Installation guide

1.5 SP1 02/09 SERVICE PACK RELEASE:
Added sections on how to configure fax redirect, automatic phone
relocation, and call return for external calls.
16-15,
16-25,
16-28
1.5 01/09 GENERAL RELEASE (IP 500):
The Wave IP 500 Server is now supported. Unless otherwise specified,
the information in this manual applies to both the Wave IP 500 and
Wave IP 2500 Servers.
---
1.5 11/08 GENERAL RELEASE:
The term “Wave Server” now refers to the physical server PC on which
Wave ISM runs. When information applies to a specific Wave Server
model, the model is identified, for example “Wave IP 2500” or “Wave
IP 500”.
throughout
Expanded sections covering starting, using, and exiting dialog applets
and remote access applets in the Global Administrator Management
Console.
starting on
page 2-5
Documented the new System Settings field
Limit the number of
external calls that can be routed to simultaneously
, used to limit the
number of external numbers that can be called simultaneously by a
ViewPoint routing list action, in order to avoid consuming all Wave ISM
trunks.
4-5
Removed the chapter “Configuring Outside Lines” and incorporated
the material into Chapter 5, “Configuring Analog and Digital Trunks”.
5-2
Updated and expanded information on configuring Vertical-branded SIP
phones, including the Aastra 5-series SIP phones that are now
supported. See sections “Configuring SIP phone extensions” and
“Configuring Vertical-branded SIP phones”.
starting on
page 6-23
Updated IP telephony codec configuration guidelines to recommend
use of G.711U codec only in most implementations.
6-29
Added note about an important Media Resource Module (MRM)
requirement to “WAN Quality Of Service settings” section.
6-47
Added a summary table in section “Available digital and SIP phone
features” that lists all features that can be assigned to phone feature
buttons, identifying which features can be assigned on digital phones,
IP phones, or both.
10-10
Revision History
Release Date Documentation Changes Page No.
Release 2.0
September 2010