User guide

ViewPoint command line switch reference B-3
Appendix B: Logging On with Command-Line Switches
Wave ViewPoint User Guide
Using the /station command
The /station command associates ViewPoint with a specific phone, either a station ID or a
remote number. You can use this switch to set up various ViewPoint shortcuts for different
remote locations, so you don’t have to wait for ViewPoint to launch, then choose
File > Use a
different station
, and wait for it to launch again.
Syntax
/station:<station number/remote number>
For
<station number> , specify a station ID, for example /station:77 .
For
<remote number> , use the following syntax:
<access code><extension/phone number/IP address>
•
access code. Syntax: ac=<code> . Example: ac=9 . Specifies the dialing service
access code for Wave to use when placing calls to you. If omitted, Wave uses the
default dialing service for your number type.
•
phone number. Syntax: phone:<+><number> . Example: phone:[phone] .
Include the + to have Wave use dialing rules when dialing the number. Omit the + to
have Wave dial the number exactly as you enter it without applying dialing rules.
•
IP address. Syntax ip:<address> . Example: ip:11.22.33.44. Example:
ip:dotcomaddress.com/1234 . As when entering IP addresses in ViewPoint, you
can specify the address by either name or number, and optionally add a slash and
append a dial-through number for H.323 Gateways.
Examples
/station:0
/station:phone:[phone]
/station:ac=77;phone:[phone]
/station:ip:foo.bar.com/1234
/station:ac=68;ip:foo.bar.com/1234