System information

APPENDIX J. TELEVANTAGE CONFIGURATION SETTINGS J-47
Server\SendDigitsToStationDelay
DWORD value that specifies the delay (in millseconds) before sending digits to a
station, for example, DID digits.
Default value is
0 milliseconds.
Server\TrunkAllocationInterval
DWORD value that specifies the amount of time (in milliseconds) that dialing services
wait before trying to allocate another trunk. This is only used when a trunk is not
responding. If you decrease this value, you also need to decrease
WaitLoopCurrenttimeout (see page J-9.)
Default value is
1800 milliseconds.
Server\TUIIdleTimeout
DWORD specifying number of milliseconds before the TUI times out. Timeout causes
a trunk to hang up. When a station times out, the re-order tone will play and then the
station will be disabled until it is hung up.
Default is
120000 milliseconds.
Server\TUITransferRingDelay
LONG value specifying the amount of time (in milliseconds) that the server waits
before ringing the recipient’s phone on call transfers using the telephone commands.
The delay gives the transferer time to hang up when performing a blind transfer.
Increasing the ring delay can avoid extra ringing of the recipient’s phone that may cause
confusion.
Default value is
5000 milliseconds.
Server\UISupportIdleTimeout
DWORD specifying the time in milliseconds before a station goes to dialtone after
ViewPoint plays or records audio. Note that if a station is taken off-hook automatically,
the timeout is this setting or 10 seconds, whichever is less.
Default is
120000 milliseconds.
System database settings