System information

APPENDIX J. TELEVANTAGE CONFIGURATION SETTINGS J-41
Server\DirectCallsUseFaxTarget
DWORD value that determines whether incoming faxes on DID calls are diverted to the
Send faxes to extension for the trunk. When enabled, faxes are diverted, but all trunks
on the span must use the same fax target. When disabled, DID calls are always routed
to the user whose DID number is being dialed, even when they are fax calls.
Default value is
0 (disabled.) Can be set to 1 (enabled.)
Server\DropMonitorsAfterTransferComplete
DWORD value specifying whether supervisors on a call are disconnected when the user
they are supervising is transferred to a new third party, or parked and then unparked by
a new third party. Supervisors are users who have used the
Coach or Monitor command
on the call.
The default is
1 (supervisors are disconnected when the supervised user is transferred.)
Can be set to 0, in which case supervisors remain with the call as long as the new third
party doesn’t prohibit supervision.
Note that the supervisor is always disconnected if the supervised user leaves the call, or
if a user who prohibits supervision enters the call.
Server\E911RingDuration
DWORD value that specifies the number of milliseconds to ring E-911 stations before
dialing out of trunk.
Default value is
4000 millseconds (4 seconds.)
Server\EmailNotifyAddSubmittedTime
BOOLEAN value specifying whether TeleVantage adds a line to the body each e-mail
notification of a new voice message, listing the timestamp when TeleVantage submitted
the e-mail to the e-mail server. Use this setting to help debug delays in e-mail
notification.
Default is
0 (timestamp not included.) Set to 1 to include the timestamp.
Server\EnableIPAddressMatch
DWORD value specifying whether IP phones defined as external stations require a
connection string of *<ext>*<pwd>*. The setting applies especially to Uniden IP
phones. The default of
0 means that a connection string is not required, and the IP phone
connects to TeleVantage automatically using IP address matching. This setting has
some security risk. Can be set to
1, in which case the connection string is required.
System database settings