System information

J-30 INSTALLING TELEVANTAGE
Robbed Bit T1 Setting
The setting IgnoreSpuriousSignals should be activated only in cases where all other efforts to
configure Robbed Bit T1 signaling correctly have failed (see “Adding a digital Robbed Bit T1
span” in Chapter 5 in Administering TeleVantage.)
HKLM\SOFTWARE\Artisoft\TeleVantage\Server\DTIBoard<n>\
E1 and T1 board settings
In the following lists, Board<n> refers to a Dialogic board number. See “Dialogic device
names” on page J-24 for an explanation of board numbering conventions.
HKLM\SOFTWARE\Artisoft\TeleVantage\Server\DTIBoard<n>\GlobalCall
DXCH_WINKLEN
DWORD value for
Wink Length. The duration of a wink in the off-hook state (10ms
units.)
Default is
15.
..\Server\VoiceBoard<n1>\Line<n2>
\Server\DTIBoard<n>
IgnoreSpuriousSignals
DWORD value to aid correct Robbed Bit T1 configuration when other methods have
failed. If enabled, the IgnoreSpuriousSignals setting makes TeleVantage ignore certain
signals if the device is offhook.
To enable, set to
00000001.
To disable, set to
00000000.
\Server\DTIBoard<n>\GlobalCall
CIDName...
The CIDName settings allow you to customize how your system receives Calling Name
Identification on PRI lines. See the next section, “Configuring Calling Name
Identification on PRI boards.”
DumpCallInfo
DWORD value specifying whether or not to include raw call-event information
elements from E1 and T1 trunks (ISDN PRI, robbed-bit, CAS) in the TeleVantage
Server log (filename format
Tvlogxxx.txt.)
Default is
0, which suppresses the information element logging. Set to 1 to include the
information elements in the log.