System information

J-24 INSTALLING TELEVANTAGE
3. Create a DWORD Value ConfPriority under the key you created in the previous step
(if it does not already exist), and set it to 100 (highest priority), 200 (medium priority),
or 300 (lowest priority.)
4. To change the conference priority of additional boards, repeat steps 2-3 for each board.
5. Save the changes to the registry.
Dialogic device names
Dialogic system software creates standard names for devices and channels within devices.
These names are used to open the devices to receive device handles, which are used in all
subsequent Dialogic driver functions.
Dialogic telephony board device names
A Dialogic telephony board device name has the form DXXXBnCn, where Bn is the board
number and
Cn is the channel number. For example, Channel 1 on Board 1 would be named
DXXXB1C1. If multiple telephony boards have been installed, the board number 1 is assigned
to the Dialogic telephony board that was installed in the TeleVantage Server with the lowest
board ID. (For information about setting Dialogic board IDs, see Installing Dialogic Telephony
Components.) The board number is then incremented by 1 for every four voice ports. The
channel number is assigned sequentially starting with 1 each time the board number changes and
incremented by 1 for each voice channel. Whenever all the devices on one Dialogic telephony
board have been named, the board-numbering sequence continues on the Dialogic telephony
board that was installed with the next lowest board ID.
For example, if you installed a Dialogic D/120JCT-LS in the TeleVantage Server with the board
ID set to 0 and a D/41JCT-LS with the board ID set to 1, the devices on these boards would have
the names shown in the following table.
Board Board ID Channel
D/120JCT-LS 0 DXXXB1C1 - LSI/VOX
DXXXB1C2 - LSI/VOX
DXXXB1C3 - LSI/VOX
DXXXB1C4 - LSI/VOX
DXXXB2C1 - VOX
DXXXB2C2 - VOX
DXXXB2C3 - VOX
DXXXB2C4 - VOX
D/41JCT-LS 1 DXXXB3C1 - LSI/VOX
DXXXB3C2 - LSI/VOX
DXXXB3C3 - LSI/VOX
DXXXB3C4 - LSI/VOX